![]() Unfortunately, it continually reverts back to a presumably default start setting of manual, in lieu of automatic, start. When I change back to "Local Asset (recommended)", I find that the program appears to only scan the WAV folder and thus create only a single entry for each track. as a "service" that it was, indeed, scanning the entire music folder and seeing BOTH the wav and mp3 files, thereby duplicating each track. However, I later discovered after making this change, the configuration settings for Asset changed from "Local Asset (recommended)" to "Service" it was in the latter configuration, i.e. Macbook Pro 2010->DLNA/UPNP fed by Drobo->Oppo BDP-93->Yamaha RXV2065 ->Panasonic GT25 -> 5. I selected "services" and changed the start parameter to "automatic" which worked fine. If you use local storage its actually one of the best out there. (This can normally be initiated by a desktop shortcut with “ )Ĥ.Ĝheck that under Devices, get more detail and check your PC/Mac/iPhone/iPad have been selected as either "Generic Media Receiver" or "Linn Kinsky Desktop control point" with your Music tree selecton.Well I have been working to get this set up properly and have noted the following: Firstly, I wrote earlier about my desire to have Asset start automatically, in lieu of manually, which was the setting I initially encountered. I have selected dbPoweramp to rip the CDs and have installed Asset uPnP on the server to assist with managing the library. I am setting up a NAS server for my music. This means that a manual scan has to be promoted when any media is added. Greetings: I am a neophyte regarding servers, so excuse a potentially naive question. Once opened, select the Setings icon, this will open the Twonky configurationĢ.Ĝlick on “Advanced” and Change “Rescan interal” to 0. Twonky 7&8 can be changed using the Tree navigational Builder within Setup.ġ. Twonky will now start from scratch and build to database ready for the DS to use. Go back to “first steps” tab and click “Restart” tab and wait for server to restartĦ.Ĝlick on “Maintenance” and “Rebuild database”. (This can normally be initiated by a desktop shortcut with “ )ĥ. This means that a manual scan has to be promoted when any media is added. Once opened, select the Spanner icon, this will open the Twonky configurationĢ.Ĝlick on “first steps” – change to “Advanced default navigation” Save changes.ģ.Ĝlick on “Sharing”, in the Content locations section, select the “Browse” button to select your Music locationĤ.Ĝhange “Rescan in minutes” to 0. Twonky5 and Twonky6 require XML file editing.ġ. The Music tree can only be easily edited in Twonky4. However I always keep a plain text copy of my preference settings as a matter of course. Yes it’s a manual install on your NAS & all your previous settings are preserved. Now retry the iPad Kazoo and it will probably now work. Download the Synology (.spk) package from Asset, be sure you download the correct DSM6 or DSM7 specific to whatever DSM package you have. ![]() The solution is to go in the Twonky Settings > Advanced > Media receivers and RESET LIST. ![]() But you may if you go to a PC/Mac and this does allow the same Music (or vice-versa) you will probably also using Twonkymedia. TWONKY ISSUES Twonky Media music greyed out or will not play If you are looking at the Music and the Music cannot be added to the Playlist or is grayed out. You need to buy a licence and update from Twonky Downloads V8.4 (QNAPx86_64) ![]() Note: TwonkyMedia is not supported by QNAP on QNAP firmware QTS4.3 and later.
0 Comments
Leave a Reply. |